A new vector control for Brushless DC Motor using effective photovoltaic power source

Authors

  • Visvanathan K
  • SANJAY S CHAUDHARY

DOI:

https://doi.org/10.20894/IJMSR.117.007.001.015

Keywords:

PV (Photovoltaic system), Two-diode PV system, MPPT (Maximum Power Point Tracking), Fuzzy MPPT (Fuzzy based IC), VSI (Voltage Source Inverter), Sensor-Less Vector Control

Abstract

In increasing demand of non-renewable power source, renewable power generation is create impact on power demand. PV (Photovoltaic) source is having notable merits such as noiseless, pollution free and high efficient power generation over wind power generation. This paper proposed a sensor less vector control of Brushless DC (BLDC) Motor using space vector Pulse width modulation generation. Photovoltaic power sources is used for supplying power for brushless DC drive and power generation capability of PV (Photovoltaic) is improved by fuzzy logic based maximum power point tracking scheme is proposed in this paper. Proposed MPPT is a modified form of incremental conductance and its overcome demerits such as extraction in local area, extended commutation time of solar array. The control and estimation of parameters are effectively derives in proposed vector control scheme without need of additional loops. The enhanced of proposed scheme is implemented using MATLAB/Simulink results.

Downloads

Download data is not yet available.

Author Biographies

Visvanathan K

Research scholar, Department of EEE, North East Frontier Technical University, Sipu Puyi, Aalo (P.O), Arunachal Pradesh

SANJAY S CHAUDHARY

Professor, Department of EEE, Maharishi University Of Information Technology, Sitapur Road, P.O. Maharishi Vidya Mandir, Lucknow, Uttar Pradesh 226013.

References

[1] Shuang, G., Lei, D., Chengwei, T and Xiaozhong, L. (2011, April) "Novel converter of Wind Power Generation System of Non-Grid-Connection for Radio Base Station" In Electric Information and Control Engineering (ICEICE), 2011 International Conference on (pp. 2396-2400). IEEE.

[2] Hui, J., Bakhshai, A and Jain, P. K. (2010, February) "A hybrid wind-solar energy system: A new rectifier stage topology” In Applied Power Electronics Conference and Exposition (APEC), 2010 Twenty-Fifth Annual IEEE (pp. 155-161). IEEE.

[3] Emadi, A., Rajashekara, K., Williamson, S. S and Lukic, S. M. (2005) "Topological overview of hybrid electric and fuel cell vehicular power system architectures and configurations" Vehicular Technology, IEEE Transactions on, 54(3), 763-770.

[4] Yarlagadda, S. K., & Shireen, W. (2014, March) "A maximum power point tracking technique for single-phase PV systems with reduced DC-link capacitor" In Applied Power Electronics Conference and Exposition (APEC), 2014 Twenty- Ninth Annual IEEE (pp. 2950-2957). IEEE.

[5] Walker, G. (2001) "Evaluating MPPT converter topologies using a MATLAB PV model" Journal of Electrical & Electronics Engineering, Australia, 21(1), 49.

[6] Yetayew, T.T.; Jyothsna, T.R., "Improved single-diode modeling approach for photovoltaic modules using data sheet," India Conference (INDICON), 2013 Annual IEEE , vol., no., pp.1-6, 13-15 Dec. 2013.

[7] Babu, B. C., & Gurjar, S. (2014) "A novel simplified two-diode model of photovoltaic (PV) module" Photovoltaics, IEEE Journal of, 4(4), 1156-1161.

[8] Salam, Z., Ishaque, K and Taheri, H. (2010, December) “An improved two-diode photovoltaic (PV) model for PV system,” in Proc. Joint Int. Conf. Power Electron.,
Drives Energy Syst.,New Delhi, India, Dec. 2010, pp. 1–5.

[9] Y. Mahmoud, W. Xiao, and H. H. Zeineldin, “A simple approach to modelling and simulation of photovoltaic modules,” IEEE Trans. Sustainable Energy, vol. 3, no. 1, pp. 185–186, Jan. 2012.

[10] S. Liu and R. A. Dougal, “Dynamic multiphysics model for solar array,”IEEE Trans. Energy Convers., vol. 17, no. 2, pp. 285–294, Jun. 2002.

[11] Dong-Hee Kim, Gyu-Yeong Cheo, Byoung-Kuk Lee “Design and Control of an Optimized Battery Charger for an xEV Based on Photovoltaic Power Systems,” J Electr .Eng. Technol Vol. 9, No. 5: 1602-1613, 2014.

[12] Wenfei Hu, Hongfei Wu, Yan Xing, Kai Sun, “A Full-Bridge Three-Port Converter for Renewable Energy Application,” IEEE Trans. 978-1-4799-2325- 0/14. 2014.

[13] Puspendu Maji, Prof. G KPanda and Prof. P KSaha “Field Oriented Control of Permanent Magnet Synchronous Motor Using PID Controller” International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering, Vol. 4, Issue 2, February 2015,pp.632-639.

[14] Mourad Masmoudi, Bassem El Badsi, and Ahmed Masmoudi “DTC of B4- Inverter-Fed BLDC Motor Drives With Reduced Torque Ripple During Sector-to- Sector Commutations” IEEE Transactions on Power Electronics, Vol. 29, No. 9, September 2014,pp.4855-4865.

Downloads

Published

2015-12-16

Issue

Vol. 7 No. 1 (2015)

Section

Articles

License

Authors need to sign following agreement with International Journal of MC Square Scientific Research before publishing their articles:

  • Authors need to return copyright form to Journal Editor-in-chief to proceed their articles for publication. Meantime, the journal licensed under a Creative Commons Attribution License, which permits other user to distribute the work with an acknowledgement of the authors for International Journal of MC Square Scientific Research.
  •  Authors are also able to share their separate, additional contractual arrangements for the non-restricted contribution of the journal with an acknowledgement of publication in International Journal of MC Square Scientific Research.
  • Authors are allowed and encouraged to share their work during the submission process for increasing citation and exploring to increase the paper availability in worldwide way. The Effect of Open Access.